Testosterone suspension TNE Suspension 50mg/ml

TNE Suspension 50mg/ml @10ml
0.5g Test Base (0.4465ml)
0.2ml BA (2%)
1ml BB (10%)
0.3ml ps80 (3%)
8.0535ml distilled water
INQUIRE NOW!

Description

TNE Suspension 50mg/ml @10ml 

0.5g Test Base (0.4465ml) 

0.2ml BA (2%) 

1ml BB (10%) 

0.3ml ps80 (3%) 

8.0535ml distilled water 


Steps:

1) Pre-heat warmer (my benchmark is set to 3/10 for a good 15 minutes) 

2) Distill water and heat over warmer

3) If your test base is not micronized, use a mortar & pestle

4) Mix powder, BB, ps80. Mix as needed until clear and hot. 

5) Dose water into vial(s) with 0.20 um filter and keep hot (set them on the warmer) 

6) Filter BA into vial(s) and keep the vials on the warmer. 

7) Quickly extract the compound solution into syringe. Barrel will be HOT 

8) Quickly filter 1ml or less of compound solution into water vial and then shake to mix. As it combines, will turn very milky. Continue in 1ml or less quantities until all solution is mixed. 

9) Done. 


Shake before use. I always switch out my draw needle and my injection needle. I shake the syringe right before injection. This may be necessary to avoid the injection pain. Your millage may vary. 


The most popular practice with Testosterone suspension is to inject the drug at least every two or three days. The dosage will vary greatly depending on the needs of the individual, but is most often in the range of 50mg to 300mg per shot. Athletes looking to achieve an extremely rapid bulk gain will inject the already mentioned dose of 100mg daily. In most cases this cycle can be amazing, the user seeming to just "inflate" with bloated muscle mass in a short period of time. The U.S. 30m1 vials (100mg/ml) are of course the most sought after for this procedure, as each will run the cycle for about a month. Although this drug does require a frequent injection schedule, it will pass through a needle as fine as 27 gauge (insulin). This allows the user more available injection sites, hitting the smaller muscle groups such as the deltoid, triceps and calves. Although some users do complain about discomfort when injecting water-based steroids, it has been my experience that suspension is generally well tolerated. In fact Anabolics 20U many bodybuilders find the speed of drawing and administering a water based solution to be quite a welcome change from oils, which as you know can be a lengthy procedure.


Description

Write Your Own Review


Bella
Email
TOP